Liebherr ZKes 453 Humidor - Manual (Page 4)

20
Setting up
• Avoid locating the appliance in direct sunlight or near heat sources such as an oven
or a radiator.
• The floor should be level and even. You can compen-
sate for an uneven floor by adjusting the adjustable
feet.
• Please make sure the appliance is properly venti-
lated. The ventilation slots must not be covered!
• Standard EN 378 specifies that the room in which you install your appliance must
have a volume of 1 m 3 per 8 g of R 600a refrigerant used in the appliance, so as to
avoid the formation of inflammable gas/air mixtures in the room where the appliance
is located in the event of a leak in the refrigerant circuit. The quantity of refrigerant
used in your appliance is indicated on the type plate of the appliance.
• The appliance is set to operate within specific ambient temperature limits according
to its climate rating. These temperature limits should not be exceeded.
The appliance has the following climate rating: N = +16°C to +32°C.
• When installing two appliances next to each other, always leave a gap of 50 mm to
prevent condensation forming in the gap.
Humidity at the place of installation
To ensure fault-free operation of the appliance, 80% humidity at the place of installa-
tion must not be exceeded. Higher levels of humidity will cause error messages from the
electronic control system.
Dimensions Range of appliance use
This appliance is designed for storing cigars only.
The appliance is not suited for storing and cooling
pharmaceuticals, blood plasma, laboratory prepa-
rations or similar substances and products subject
to the Medical Devices Directive 2007/47/EC.
Any misuse of the appliance may result in damage
to or spoilage of the stored goods.
Furthermore, the appliance is unsuited for use in
areas exposed to an explosion hazard.