Liebherr WTes 5872 Vinidor - Manual (Page 7)

21
GB
Demo mode
Demo mode can be activated for presenting the appliance at
exhibitions or in salesrooms as though in normal operating mode.
DEMO appears in the display.
When in this mode, the cooling circuit is switched off!
If this mode is activated by accident, it can be deactivated as
detailed below.
Press + for 5 seconds.
Display =
Display =
Display =
The refrigeration unit switches on.
The temperature display flashes.
The appliance is now in normal operating mode.
Interior light
The interior of the appliance is lit by an LED light strip at the top
of each compartment.
The interior light will always switch on when the appliance door
is opened.
The interior light will go out approx. 5 seconds after the door is
closed.
Press the Light button if you want the interior light to
be on even when the door is closed.
Note
This function applies to the lighting of all three compartments.
Furthermore, the brightness of the lighting can be adjusted.
• Press the Light button.
• Press and hold the Light but-
ton and at the same time press
the temperature setting but-
tons to increase or decrease
the brightness.
Note: The brightness will change in all compartments.
The light intensity of the LED light corresponds
to laser class 1/1M.
Important
The light cover may only
be removed by customer
service staff.
If the cover is removed, do
not look directly at the light
through optical lenses from
close distance. This can
damage your eyes.
Adjusting the display brightness
Press for 5 seconds. Display =
Display =
Display =
Use buttons Up and Down to select the desired setting.
h0 = display lighting off
h1 = minimum brightness
h5 = maximum brightness
Display =
Display =
The adjusted brightness will be activated after one minute.
Note
If a button is pressed, the display lights up for one minute at
maximum brightness.
When commissioning the appliance, the adjusted brightness will
only be active once the set interior temperature of the appliance
has been reached.