Brother DCP-770CW - Manual (Page 36)

Chapter 4
28
Paper options
4
Paper Type
4
If you are copying on special paper, set the
machine for the type of paper you are using to
get the best print quality.
a
Load your document.
b
Enter the number of copies you want.
c
Press a or b to choose Paper Type.
d
Press d or c to choose Plain Paper,
Inkjet Paper
, Brother Photo,
Other Photo
or Transparency.
Press OK.
e
If you do not want to change additional
settings, press Mono Start or
Colour Start.
Paper Size
4
If copying on paper other than A4 size, you
will need to change the paper size setting.
You can copy only on Letter, Legal, A4, A5 or
Photo Card [10 cm (W)
× 15 cm (H)] paper.
a
Load your document.
b
Enter the number of copies you want.
c
Press a or b to choose Paper Size.
d
Press d or c to choose Letter, Legal,
A4
, A5 or 10x15cm.
Press OK.
e
If you do not want to change additional
settings, press Mono Start or
Colour Start.
Setting your changes as a
new default
4
You can save the copy settings for Quality,
Paper Type
, Brightness, Contrast,
RED Adjust
, GREEN Adjust and
BLUE Adjust
that you use most often by
setting them as the default settings. These
settings will stay until you change them again.
a
Press a or b to choose your new setting.
Press OK.
Repeat this step for each setting you
want to change.
b
After changing the last setting, press a
or b to choose Set New Default.
Press OK.
c
Press + to choose Yes.
d
Press Stop/Exit.
Restoring all settings to the
factory settings
4
You can restore all the settings you have
changed to the factory settings. These
settings will stay until you change them again.
a
Press a or b to choose
Factory Reset
.
Press OK.
b
Press + to choose Yes.
c
Press Stop/Exit.