Brother DCP-770CW - Manual (Page 54)

Chapter 5
46
d
Press a or b to choose
Scan to Media
.
Press OK.
e
Do one of the following.
„ To change the quality, go to step f.
„ Press Mono Start or Colour Start to
start scanning without changing
additional settings.
f
Press a or b to choose Color 150dpi,
Color 300dpi
, Color 600dpi,
B/W 200x100dpi
or B/W 200dpi.
Press OK.
g
Do one of the following.
„ To change the file type, go to step h.
„ Press Mono Start or Colour Start to
start scanning without changing
additional settings.
h
Press a or b to choose JPEG, PDF or
TIFF
.
Press OK.
Note
• If you chose colour in the resolution
setting, you cannot choose TIFF.
• If you chose monochrome in the resolution
setting, you cannot choose JPEG.
i
Press Mono Start or Colour Start.
Understanding the
Error Messages
5
Once you are familiar with the types of errors
that can occur while you are using
PhotoCapture Center™, you can easily
identify and troubleshoot any problems.
„
Hub is Unusable.
This message will appear if a Hub or USB
Flash memory drive with a Hub has been
put into the USB direct interface.
„
Media Error
This message will appear if you put in a
memory card that is either bad or not
formatted, or when there is a problem with
the media drive. To clear this error, take
out the memory card.
„
No File
This message will appear if you try to
access a memory card or USB Flash
memory drive in the drive (slot) that does
not contain a .JPG file.
„
Out of Memory
This message will appear if you are
working with images that are too large for
the machine's memory. This message will
also appear when a memory card or USB
Flash memory drive you are using does
not have enough available space for the
scanned document.
„
Media is Full.
This message will appear if you are trying
to save more than 999 files in a memory
card or USB Flash memory drive.
„
Unusable Device
This message will appear if a USB device
or USB Flash memory drive that is not
supported has been connected to the USB
direct interface. Fore more information,
visit us at http://solutions.brother.com.
This message will also appear if you
connect a broken device to the USB direct
interface.