Brother HL-1060 Series - Manual (Page 75)

USER’S GUIDE
CHAPTER 6 –12
Setting Up the Printer for Apple Macintosh Computers
When Using the Optional RS-100M Serial Interface
Question Recommendation
I cannot print from my
application software.
•
Make sure that the supplied Macintosh printer
driver is installed in the System Folder and it is
selected with Chooser.
•
Check the PORT selection within the Chooser: it
should match the port to which you physically
attached the printer cable.
•
The serial slide switch of the optional interface
board should be in the Apple (RS-422A) position.
•
Check the printer cable type: you cannot use a
LocalTalk or straight-through cable. Refer to
Chapter 4 for details on printer cable type.
When Using the Optional BR-Script 2 ROM Board BR-3000
Question Recommendation
The printer does not print. Check the following:
•
The printer is plugged in.
•
Paper is loaded.
•
No error conditions are active (any blinking lamps
on printer.)
•
Printer is on-line.