Bushnell Tour V2 - Manual (Page 14)

14
TrOUBLe SHOOTING TaBLe
If unit does not turn on - LCD does not illuminate:
• Depress POWER button.
• Check and if necessary, replace battery.
If unit does not respond to key presses, replace the battery with a good quality 3 volt lithium battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality
3 -volt lithium battery.
If target range cannot be obtained:
• Make sure LCD is illuminated.
• Make sure that the power button is being depressed.
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses
(lenses closest to the target) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
NOTe:
The last range reading does not need to be cleared before ranging another target. Simply
aim at the new target using the LCD’s reticle, depress the power button and hold until new range reading is
displayed. Specifications, instructions, and the operation of these products are subject to change without notice.
201930_33 Tour V2 6LIM.indd 14 8/26/08 2:40:25 PM