SoundMax SM-2403 - Manual (Page 6)

6
Erase protection
To prevent accidental erasing of a cassette, simply break off the two plastic tabs
located on the cassette tape’s rear side.
When a cassette with removed plastic tabs is inserted, the recording button cannot
be pressed.
If a cassette is to be erased and re-recorded at a later stage, simply cover the holes
on the cassette where the tabs were removed, with a piece of strong adhesive tape.
Compact disc operations
Set Function switch to CD position.
Open the CD door by pulling up CD door.
Put a CD into the CD compartment with label side up and close the CD door by pulling it down gently.
Play/pause mode
Press the PLAY/PAUSE button to start play.
Press the PLAY/PAUSE button to pause at any track when playing.
To stop the CD, press the STOP/FOLDER button.
To remove the CD from the unit open the CD door by pulling up CD door.
Always press STOP/FOLDER button before opening the CD compartment.
Skip and search mode
Press the CD Skip/Search Forward button once to skip to the next track. Press and hold this button to
search for a particular point at high-speed forward. Release the button to resume normal play.
Press CD Skip/Search Backward button once to skip back to the beginning of the current track, twice to
skip back to the beginning of the previous track. Press and hold this button to search for a particular point at
high speed backward. Release the button to resume normal play.
Playback modes
Press REPEAT button repeatedly to switch between different playback modes.
During Playing the mode will change as below:
While playing Audio CD:
- Press REPEAT button once for single track repeat playing.
- Press REPEAT button twice for all tracks repeat playing.