Burley LE Tiger d'lite - Manual (Page 5)

B U R L E Y C H I L D T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L | 
Attaching the Seat
d’lite , ™ Solo, ™ and Tiger d’lite: Fasten male and female buckle
parts together on straps behind seat. Adjust as needed. To fold,
these buckles will need to be unclipped. Photo 1
Encore
™ : Fasten buckle parts on strap, and attach hooks on
seat sides to D-rings by windows. To fold, unclip buckles. Photo 2
Mounting Reflectors
Mount clear reflectors on trailer front and red reflectors on
trailer rear. From inside of trailer, insert screws through
grommets and into reflector backs. Tighten snugly. Photo 3
Installing Wheel Guards
Match holes in wheel guards with holes on outside of lower side
frames. From inside of
frame, install guards
using the hex key
wrench (included)
to secure the
(2) M6 x 35mm
screws. Tighten. Figure 3
Attaching Wheels
Insert wheel axle
assembly completely
into trailer axle. Close quick release lever, with lever aimed at
trailer rear. A properly adjusted quick release lever should leave
an imprint on your palm when the lever is rotated to the closed
position. Figures 4 & 5 Verify that tires are inflated to pressure
marked on tire side wall.
Photo 3
Photo 2
Figure 4 Figure 5
Quick-release lever
in unlocked
“Open” position
Quick-release
lever in locked
“Closed” position
WARNING
MAkE SURE WHEELS ARE HELD SECURELY, WITH WHEEL SHAFT FULLY INSERTED INTO
HOLLOW AXLE. YOU SHOULD NOT BE ABLE TO ROCk OR SHIFT WHEELS. IMPROPERLY
INSTALLED WHEELS CAN FALL OFF, CAUSINg AN ACCIDENT OR SERIOUS INjURY.
MAkE SURE REFLECTORS ARE MOUNTED HORIzONTALLY. INCORRECTLY INSTALLED
REFLECTORS CAN REDUCE vISIBILITY AND CAUSE AN ACCIDENT OR SERIOUS INjURY.
IMPORTANT:
IMPORTANT:
ALWAYS kEEP SEAT ATTACHMENTS FASTENED WHILE TRAILERINg.