Burley LE Tiger d'lite - Manual (Page 8)

 | B U R L E Y C H I L D T R A I L E R O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N U A L
Two passengers:
For two children, use both shoulder harnesses and two outer
crotch straps.
1. Seat first child on one side of seat.
2. Snap shoulder straps into Y-buckle,
with buckle positioned at child's
sternum. Adjust straps so that child
cannot move too far forward in seat.
3. Repeat for second child.
4. Fasten and adjust lap belt
snugly. Figure 9
To remove children from seat, release lap belt and
harness buckles.
Hitching Trailer to Your Bicycle
Figure 10
1. Remove rear quick release lever assembly from bike.
2. Match hole on flat side of hitch upper arm to left (non-chain
ring side) rear dropout hole.
3. Loosely reassemble quick release assembly through hitch,
dropout and wheel.
4. Slide flex connector between hitch side arms, and match
holes. Racks, bags, or fittings should not interfere with hitch.
5. Open retaining pin and insert through hitch and flex
connector holes. Rotate and close spring clip.
6. Tighten and close quick release lever, with lever pointing to
rear of bike. A properly adjusted quick release lever should
leave an imprint on your palm when the lever is rotated to the
closed position.
7. Wrap safety strap twice around chain stay and then over
hitch body. Fasten hook to D-ring on underside of tow bar
end.
8. To remove trailer from bicycle, unfasten clip from D-ring and
remove retaining pin.
WARNING
ALWAYS SECURE CHILDREN WITH HARNESS AND LAP BELT DURINg USE. ONLY USE
THIS SEAT IF YOUR CHILD IS CAPABLE OF SITTINg UPRIgHT ALONE. FAILURE TO DO SO
COULD RESULT IN ACCIDENT AND SERIOUS INjURY OR DEATH.
WARNING
qUICk RELEASE LEvER MUST BE IN CLOSED POSITION AND HITCH SAFETY STRAP
PROPERLY INSTALLED. HITCH MUST NOT INTERFERE WITH RACkS, BAgS OR FITTINgS.
INSPECT HITCH AND TOW BAR FREqUENTLY FOR DAMAgE OR LOOSE FASTENERS.
DAMAgED, IMPROPERLY INSTALLED OR INTERFERINg PARTS CAN CAUSE ACCIDENTS
RESULTINg IN SERIOUS INjURY.