Assembly guide, Attaching optional quiver, Installing cable slide – Barnett Crossbows Penetrator 350 User Manual
Page 6
Assembly Guide
Attaching Optional Quiver
IMPORTANT: Quiver must be installed
prior to attaching the bow assembly.
• Locate the picatinny rail on the underside of
the stock (in front of forearm).
• Slide the quick detach quiver bracket on the
rail. Line up the quick detach quiver bracket
with one of two optional quiver placement
holes. (See Figure 1) Attach with the screw
provided.
• Attach quiver by placing it on the quick detach bracket
with the plastic studs facing the mounting plate at a
slight angle and twist to secure.
6
Installing Cable Slide
When viewing the cable slide from the side, with
the concave surface facing up, notice that one of
the two cable notches is positioned deeper into
the cable slide than the other. See Figure 2.
IMPORTANT: Cable slide must be installed prior to
attaching the bow assembly.
• Apply Barnett lubewax to the top of the cable
slide (the part that comes in contact with the un-
derside of the flight track in the stock).
• Place the top cable into the deeper of the two
notches and the bottom cable into the more shal-
low notch on the cable slide. This allows the cable
slide to maintain a relatively level position on top
of the two cables. See Figure 3.
Fig. 2
Fig. 3
Fig. 4
Quiver Placement
holes
Fig. 1
*If you have any questions or need any assistance during
this step, please call us at (727)234-4999
Deep Groove Shallow Groove
End View of Cable Slide