Barnett Crossbows Penetrator 350 - Manual (Page 9)

9
Loading your Crossbow
• IMPORTANT : Barnett recommends only using arrows with half
moon nocks. See Figure 8.
• When loading arrows onto the flight rail, be sure that the
odd colored fletch is placed in the flight groove and that the
concaved portion of the nock is parallel to the string.
• Slide the arrow under the arrow retainer spring and fully into
the trigger mechanism. Note: The arrow retainer spring should
only exert enough pressure to hold the arrow in place without
lifting the arrow from its position on the flight surface.
Firing your Crossbow
To fire the arrow from your crossbow:
• Point the crossbow in a safe direction.
• Make sure the arrow retainer spring has maintained the arrows
fully loaded position into the trigger mechanism
• Push the safety forward to the off position. NOTE: The ANTI-DRY
FIRE Trigger mechanism will not allow the safety to release
without an arrow fully loaded into the trigger mechanism.
• The crossbow will now fire when the trigger is pulled. The safety
MUST be disengaged in this manner prior to every shot.
BE SURE TO KEEP YOUR FINGERS BELOW THE STOCK FORE
END (FLIGHT TRACK) WHILE SHOOTING. Note photos below.
Fig 8
Half Moon Nock
CORRECT INCORRECT