Buhler 595 - Manual (Page 17)

15
Attaching the Loader to Your Tractor
(Continued)
6. When the hook is lined up, dump or roll back the bucket to lower or raise the subframe
upright to align with the mounting boot.
7.
Continue to drive the tractor forward until the subframe uprights are seated in the boot.
8.
Secure the subframe uprights with the bolts and washers. Torque to 500 ft-lbs.
IMPORTANT: When mounting for the first
time, the front hook bolts will have to be
tightened after positioning the hook
directly over the mounting boss (most
rearward position).
9.
Raise the loader and lock the support stand tubes into the up position.
NOTE: When mounting for the first time,
raise the loader slowly and check to make
sure that the hoses do not bind or become
pinched in all positions. Work the loader and
bucket up and down to work out all the air in
the hydraulics. Check and refill the tractor’s
hydraulic system.