Billion Electric Company CO1 - Manual (Page 25)

Billion BiGuard VPN Client
Chapter 4: VPN Configuration
22
If this identity is not set, VPN gateway's IP address is used.
IPSec Configuration or Phase 2
What is Phase 2?
“IPSec Configuration” or “Phase 2” window will concern settings for Phase 2.
The purpose of Phase 2 is to negotiate the IPSec security parameters that are applied to the
traffic going through tunnels negotiated during Phase 1.
Phase 2 Settings Description
Name:
Label for IPSec Configuration only used by the VPN client. This parameter is never
transmitted during IPSec Negotiation. It is possible to change this name at any time and read it
in the tree list window. Two Phases cannot have the same name.
VPN Client address: Virtual IP address used by the client inside the remote LAN: The
computer will appear in the LAN with this IP address. It is important this IP address not to
belong to the remote LAN (e.g., in the example, you should avoid an IP address like
192.168.1.10).
Address type:
The remote endpoint may be a LAN or a single computer. In the first case
choose "Subnet address". Choose "Single address" otherwise. When choosing "Subnet
address", the two fields "Remote LAN address" and "Subnet mask" became available. When
choosing "Single address", only the field "Remote host address" is available.