Bowe, Bell + Howell 1400 - Manual (Page 52)

51
Scanner Status and Error Code
Displays the status of the connected scanner and the error code according to the condition of the scanner.
Refer to the Troubleshooting section for
Error Code and Status Message details page 56.
Scanner Information
Displays the following information .
• Product ID
• Firmware version
• Interface
STI USB (HS) = USB 2.0 Hi-Speed (default configuration)
STI USB (FS) = USB 1.1 Full Speed
ASPI SCSI = SCSI (invalid configuration. No ASPI driver included.)
STI SCSI = SCSI (using installed scanner driver.)
• Terminator condition (only with SCSI Interface)
• Imprinter condition (only pertains to Model 1400uU)
Sleep Mode button
Opens the [Sleep Mode] dialog box. Refer to the Sleep Mode Dialog section for more information .
Clean Imprinter button
If the ink-jet is stopped up, please use this button to clean the imprinter. This button is enabled only when the
imprinter is attached.
Scanner Counters
Displays scanner counters. The scanner has three counters. Here are their descriptions:
System
Displays the total number of documents scanned.
After Clean Roller
Displays how many documents have been scanned since the last time the rollers have been cleaned.
Warning indicates how many documents can be scanned between the times the rollers need to be
cleaned. When the After Clean Roller count is greater than Warning count, rollers need to be cleaned.
After Replace Roller
Displays how many documents have been scanned since the last time the rollers were replaced.
Warning indicates how many documents can be scanned between the time the rollers need to be
replaced and the time the rollers were last replaced. When the After Replace Roller count is greater
than the Warning count, the rollers need to be replaced.
Update All Counter button
Updates the scanner counters. Click this button to display the latest counts.
Clear Counter button
There are two Clear Counter buttons. One clears the After Clean Roller counter, the other clears the After
Replace Roller
counter.
• Click
Clear Counter button for After Clean Roller when cleaning the rollers.
• Click
Clear Counter button for After Replace Roller when replacing the rollers.