Blount 633GC User Manual
Page 16
633GC OPERATOR’S MANUAL
16
© 2006 ICS, Blount Inc.
P/N 70944 Feb 06
SYSTEM CLEAN-UP
• After cutting, run the saw for at least 1 seconds with the water on to flush slurry and debris from
chain, bar and drive sprocket.
• Wash concrete slurry from saw assembly.
• Avoid getting any water in the carburetor or exhaust system. If water enters exhaust port, point
the bar tip down and pull the starter handle several times to expel water from muffler.
• Remove bar and chain. Flush out the chain tensioner with high water pressure and lubricate with
grease.
• After cleaning the saw, spray the entire saw body, chain, bar, and drive sprocket with lightweight
oil. Using lightweight oil on the saw will minimize rust and help reduce slurry build up.
OPERATION