Blount 633GC - Manual (Page 6)

633GC OPERATOR’S MANUAL
6 © 2006 ICS, Blount Inc. P/N 70944 Feb 06
SAFETY
CAUTION
THE FOLLOWING SYMBOL APPLIES TO ALL ITEMS LISTED ON THIS PAGE
A potentially hazardous situation exists which, if not avoided,
may result in minor or moderate injury or property damage.
• Always turn a diamond chainsaw OFF when performing maintenance on the saw
including chain tensioning.
• Never use equipment that is not functioning properly. Have the saw repaired by qualified
service personnel.
• Turn engine OFF before refueling. Keep away from open flame. Always provide adequate
ventilation when handling fuel. Move diamond chainsaw at least 10 feet (3 m) away from
refueling area before starting.
• SealPro ® diamond chains require a minimum water pressure of 20 psi (1.4 bar).
Insufficient water supply may result in excessive wear to the chain, which can lead to
loss of strength and chain breakage.
• Never start a diamond chainsaw unless the bar, chain and
side cover are properly installed.
GENERAL SAFETY PRECAUTIONS
• Always wear protective clothing, including hard hat, eye protection, hearing protection, and
gloves.
• Avoid loose fitting clothing.
• Perform safety checks before starting each day.
• Always operate tool with solid footing and with both hands on saw.
• Remove or control slurry to prevent slippery conditions while cutting.
• Be sure there are no obstructions (plumbing, electrical conduit, air ducts) and no unnecessary
people present.
• Set up a well-marked safety zone with a roped boundary and clear signs.
• Provide adequate ventilation when working in an enclosed area. Breathing exhaust gases is
dangerous.
• To avoid electrocution, check for live electrical wiring near cutting area.