Black & Decker Dust Buster AA045020D - Manual (Page 13)

13
ENGLISH
Warning! Keep electrical appliances out
of reach from children or infirm persons.
Do not let them use the appliances
without supervision.
Features
1. On/off switch
2. Dust bowl
Fig. A
3. Crevice tool
4. Brush tool
Installation
Fitting the charging base to the
wall (Fig. B1 & B2)
The charging base can be placed on a
worktop or fitted to the wall to provide a
convenient storage and charging point
for the appliance.
Assembly
Fitting the accessories (Fig. A & C)
The appliance is supplied with the following
accessories:
◆
a crevice tool (3) for confined spaces
◆
a brush tool (4) for furniture and
stairs
To fit an accessory, proceed as follows:
◆
Take the accessories from the
appliance.
◆
Insert the appropriate accessory into
the front of the appliance.
You may refit the other accessory by
clicking it into the accessory holder.
To refit both accessories:
◆
Push the accessories down until they
click into place.
Use
◆
The appliance can be charged while
placed on a worktop or hung on the
wall using the wall hook provided.
◆
Before first use, the battery must be
charged for at least 16 hours.
◆
Leave the appliance connected to the
charger whenever it is not in use.
Charging the battery
◆
Make sure that the appliance is
switched off. The battery will not be
charged with the on/off switch in the
on position.
◆
Fit the appliance properly on the
charger aligning the arrow on the
charger with the split of the appliance.
◆
Plug in the charger. Switch on at the
mains.
◆
Leave the appliance to charge for at
least 16 hours.
While charging, the charger may become
warm. This is normal and does not
indicate a problem.
Warning! Do not charge the battery at
ambient temperatures below 4 °C or
above 40 °C.
Switching on and off (Fig. D)
◆
To switch on, slide the on/off switch
(1) forward.
◆
To switch off, slide the on/off switch
back.
Cleaning and maintenance
Warning! Regularly clean the filters.
◆
Before first use, the battery must be
charged for at least 16 hours.
◆
Do not leave the appliance connected
to the charger for more than 48
consecutive hours.
Cleaning the dust bowl and filters
(Fig. E & F)
The filters are re-usable and should be
cleaned regularly.
◆
Remove the dust bowl (2) by turning
counterclockwise.
◆
Empty the dust bowl.
◆
Remove the filter assembly (5) by
twisting it counterclockwise.
◆
Wash the filters in warm, soapy
water. The bowl can also be washed
if necessary. Do not immerse the
appliance in water.
◆
Make sure the dust bowl and filters
are dry.
◆
Refit the filter assembly (5) onto the
appliance twisting it clockwise until it
locks into place.
◆
Refit the dust bowl onto the
appliance. Make sure the dust bowl
clicks into place.
◆
For a better battery life, it is recommended
to fully run the battery down and recharge
it at least once a month.