New Buck Corporation CDVB200 - Manual (Page 23)

MOUNTING OF GLASS COVER DOOR
(1) Place the bottom tab of the Front Glass Cover Door
into the lip on the bottom of the front of the Burner Sys-
tem (CDV Firebox).
(2) Push the top of the Front Glass Cover Door inward align-
ing the two notches in the Glass Cover Door with the two
holes at the top of the Burner System (CDV Firebox), then
secure the Glass Cover Door to the Burner System with the
two 1/4-20 Bolts provided.
GLASS COVER DOOR
FRONT OF
BURNER SYSTEM
(CDV)
2 (TWO)
1/4-20 BOLTS
Glass Care: This appliance has a large cover door bolted to the front area of the firebox. This cover door must
be in place at all times when the appliance is in operation. For the most visual performance with your appli-
ance it is good to maintain a clean glass on the cover door. To clean the glass first make sure the glass is cool,
NOTE: (not hot), trying to clean the glass when it is hot can cause personal injury, or damage your cleaning device and
the glass. With the glass at room temperature and the door attached to the appliance, spray the glass with
household glass cleaner and wipe clean with a lint-free towel. NOTE: Do not use abrasive cleaners.
“WARNING: Do not abuse the glass cover door such as striking or slamming shut. The
glass can break and cause personal injury.”
CAUTION: If the glass in your appliance becomes broken or cracked, remove the glass
with caution. Wear safety glasses, gloves, shoes and other protective clothing as needed.
See your dealer or the manufacturer for replacement glass or cover door.
WARNING: Do not substitute any parts or materials.
WARNING: “Do not operate
appliance with the glass front
removed, cracked or broken.
Replacement of the glass should be
done by a licensed or qualified
service person.”
Replace the entire cover door assembly if glass
becomes defective with part # PGCDV081.
19