Black & Decker PW1750 - Manual (Page 6)

4. Disconnect the garden hose from the
water inlet.
5. Without garden hose connected to unit,
turn unit on for a few seconds and squeeze
gun trigger until water spray stops. Turn off
switch immediately.
6. Remove any remaining fluid from
detergent tank.
7. Wrap power cord on rear of unit, clipping
plug onto cord as shown in Figure 30.
8. Disconnect the high pressure hose from
the high pressure outlet and drain hose by
pressing gun trigger.
9. Engage the gun safety catch.
10. Wrap high pressure hose on front of
unit as shown in Fig. 31.
IMPORTANT: Store pressure washer
indoors away from areas that might freeze
to avoid seriously damaging the pump.
GENERAL CLEANING TIPS
• Remove the fan wand (D) from the gun
wand (F) as shown in Figure 28.
• Clean the nozzle with the cleaning tool (O).
Remove any dirt from the fan wand nozzle
hole as shown in Figure 29 and rinse.
• For cleaning tasks such as deck or brick
patio cleaning, limit your work area to
approximately 25 square feet at a time.
• Pre-rinse cleaning area with fresh water.
• Use only detergents formulated for
pressure washers.
• Always test detergent in an inconspicuous
area before use.
• Begin with a wide fan nozzle spray and
adjust the pressure to the desired spray
pattern.
• The best angle for spraying water against
a cleaning surface is 45 degrees. Spraying
head on tends to cause dirt particles to
imbed in the surface. When working on
vertical surfaces, it is best to apply
detergent starting at the bottom and working
upwards which will prevent the detergent
from sliding down and causing streaks.
SHUTDOWN / STORAGE
1. Ensure detergent tank and dispensing
system has been thoroughly rinsed as
described on page 9, and empty tank has
been replaced in unit. To empty remaining
water from detergent system put on-off
switch in “on” (I) position, and with nozzle in
outward detergent pick up position, press
gun trigger for 30 seconds. Water from the
pump will still be sprayed at low pressure
after 30 seconds, but detergent system will
be purged.
2. Put the on-off switch in “off” (O) position
and unplug the cord from the outlet.
3. Turn off water at the faucet.
O
I
31
30
11
Black & Decker (U.S.) Inc.,
701 E. Joppa Rd.
Towson, MD 21286 U.S.A.
See ‘Tools-Electric’
– Yellow Pages –
for Service & Sales
TECHNICAL INFORMATION
Operating pressure – 1250/1300psi
Maximum pressure* - 1600/1700psi
1. Maximum Water Flow rate* - 1.6gpm
2. Electrical requirements – 120V,
15amps, 60hz
3. Electrical cord – 35ft
4. High pressure hose – 25ft
5. Minimum amperage source –
15amps
6. Pressure of inlet water –
20 to 80 psi
7. Inlet water – Cold water only
8. Chemical injection rate 0.1 gpm
* Water flow and Max. pressure ratings
determined in accordance with PWMA
standard PW101.
29
MAINTENANCE
Clean the nozzle with the tool provided.
Remove any dirt from the spray wand
nozzle hole as shown in Figure 29 and
rinse.
Use only mild soap and damp cloth to clean
the tool. CAUTION: Never use the
pressure washer to clean itself.
IMPORTANT: To assure product SAFETY
and RELIABILITY, repairs, maintenance and
adjustment should be performed by
authorized service centers or other qualified
service personnel, always using identical
replacement parts.
ACCESSORIES
WARNING: The use of any accessory
not recommended for use with this pressure
washer could be hazardous.
SERVICE INFORMATION
Do not return this product to your
retailer. Black & Decker offers a full
network of company-owned and authorized
service locations throughout North America.
All Black & Decker Service Centers are
staffed with trained personnel to provide
customers with efficient and reliable power
tool service.
Whether you need technical advice, repair,
or genuine factory replacement parts,
contact the Black & Decker location nearest
you.
To find your local service location, refer to
the yellow page directory under “Tools—
Electric” or call: 1-800-544-6986.
TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this
product for two years against any defects in
material or workmanship. The defective
product will be replaced or repaired at no
charge. Do not return this product to
your retailer.
Take or send the product (prepaid) to a
Black & Decker owned or authorized
Service Center for repair or replacement at
our option. Proof of purchase may be
required. Black & Decker owned and
authorized Service Centers are listed under
“Tools-Electric” in the yellow pages of the
phone directory.
This warranty does not apply to
accessories. This warranty gives you
specific legal rights and you may have
other rights which vary from state to state
and province to province. Should you have
any questions, contact the manager of your
nearest Black & Decker Service Center.
This product is not intended for commercial
use.
Free Warning Label Replacement: If your
warning labels become illegible or are
missing, call 1-800-544-6986 for a free
replacement.
28
10