Beckett CF1400 - Manual (Page 14)

14
Form 6104 BCF23-R05
Wire the burner
— R7184B
Install the burner and all wiring in accordance with the National
Electrical Code and all applicable local codes or requirements.
Wire the burner in compliance with all instructions provided by
the appliance manufacturer. Verify operation of all controls in
accordance with the appliance manufacturer’s guidelines.
See Figure 11 for a typical wiring diagram, with R7184 oil
primary, for reference purposes only.
Figure 11. - Typical wiring (R7184B)
Legend
FD Fused Disconnect, by others TR Ignition transformer
LM Limit controls, by others M1 Burner motor
OP Operating controls, by others S1 Oil valve
PR Oil primary control, R7184 typ. T-T 24-volt thermostat/limit terminals
CC Flame sensor, cad cell typical F-F Cad cell fl ame sensor terminals
Disconnect electrical power before installing or
servicing the burner.
Provide ground wiring to the burner, metal control
enclosures and accessories. (This may also be
required to aid proper control system operation)
Perform all wiring in compliance with the National
Electric Code ANSI/NFPA 70 (Canada CSA
C22.1). y
y
y
Electrical shock can cause severe personal in-
jury or death.
Electrical Shock Hazard