Bravo View B409 - Manual (Page 5)

A.1 -
Visually inspect the parts provided by Bravo Systems for In-transit damage and/or missing
parts. Continue to keep the Sump clean of debris throughout your installation process.
A.2 -
Set your B409 Piping Sump where it must be per site plans. Secure the Sump to avoid
movement while penetrating.
A.3 -
Mark where you will penetrate the Base/Tank Collar wall.
A.4 -
Install Penetration Fittings per their respective Installation Instructions. You must NOT
disturb the penetration fittings while the sealant/adhesive is drying. Allow for the maximum cure time
as recommended by the manufacturer of the fittings before pressurizing & soaping to test for leaks.
DO NOT FILL DOUBLE WALL PENETRATION FITTINGS
WITH FOREIGN MATERIALS, SEALANTS or ADHESIVES.
5 ii-B409-DW-10A
Gauge
Assembly
SVA-BARB CAP
While Fiberglassing, curing, or sitting overnight, keep the
SVA-BARB in place. This will relieve pressure on the Interstice
while the sumps are heating up or cooling off.
SAVE THESE PIECES, DO NOT LOSE THEM! Remove the SVA-BARB when ready to test.
A - INSTALLING AND SECURING YOUR B409
BEFORE INSTALLING PENETRATION FITTINGS
ENSURE THAT THE SUMP BODY IS HOLDING VACUUM.
If the gauge is Below 12 inches of mercury (Hg/Vacuum), then pressurize the
sump interstice to 4 PSI and submerge the gauge and tubing assemblies.
Soap test the test tubing fittings on the walls. If an air leak is found, contact
the factory. If no leak at the tubing is found, soap test the rest of the sump
surface starting with the exterior. Visually inspect for damage. If the leak is found,
patch per repair directions in this manual.
If the gauge is AT OR ABOVE 12 INCHES OF MERCURY, proceed to Step A.1