West Bend Back to Basics UX-CC500 - Manual (Page 62)

Transfer Function
60
Recording the transfer message
The transfer message plays when you answer the telephone, and informs you
that the call is a transfer call. The following is an example:
“Hello. This is a transfer call for (YOUR NAME). Enter your remote code
number now.”
Note: Do not lift the handset until Step 3 below.
1
Press once and once.
2
Press once.
•
If you have already recorded a message, you can press to listen to the
message, or press to delete the message.
3
Lift the handset.
4
Press and speak into the handset to record the message.
•
The transfer message can be up to 15 seconds long. While recording, the
display will show the time left to record.
5
When finished, replace the handset or press .
REC/
MEMO
PLAY
DELETE
START/MEMORY
STOP
Display:
OGM (TRANSFER)
Checking or erasing the transfer message
To check or erase the transfer message, follow Steps 1 and 2 of the above
procedure, and then press to check the message, or to erase the
message.
PLAY
DELETE