Bunn FMD-1 User Manual
Page 5
5
PLUMBING HOOK-UP
1.
Securely attach the short piece of tubing on the water strainer assembly to the inlet fitting on the bottom of
the dispenser.
2.
Flush the water line and securely attach it to the flare fitting on the water strainer assembly.
3.
Turn-on the water supply.
INITIAL FILL & HEAT
CAUTION - The dispenser must be disconnected from the power source throughout the initial set-up, except
when specified in the instructions.
1.
Turn-on the water supply and connect the dispenser to the power source.
2.
Water will automatically flow into the tank to the proper level and then shut-off. This will take less than five
minutes.
3.
When the tank is full of water, open the front door and place the heater switch in the “ON” (lower) position.
A tank full of cold water will take approximately forty minutes for the water to heat on 120 volt versions.
During this waiting period, complete these dispenser set-up steps:
a.
Place the drip tray in front of the dispenser. Set the drip tray cover in place.
b.
Place a set of keyholes in the cup locator plate over the screws beneath the hopper access door and push
down gently.
c.
Fill the hopper with the dry product to be dispensed.
DISPENSER USE
1.
Simply place a cup on the drip tray beneath the dispensing tip.
2.
Press the button to froth and dispense the beverage.
3.
Release the button when the cup is approximately
2
/
3
full and allow the mixing chamber to drain.
NOTE - The mixing chamber must drain at the end of each dispense.
CLEANING
Refer to the decal inside the hopper access door for cleaning recommendations and procedures.
The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all
surfaces on Bunn-O-Matic equipment.
ADJUSTMENTS
The beverage solenoid is preset to dispense approximately one ounce per second. This amount can be
adjusted:
1.
Disconnect the dispenser from the power source.
2.
Remove the left side access panel.
3.
Rotate the control at the base of the solenoid clockwise to decrease or counterclockwise to increase the
amount of water.
28364 041598