Operation, Deflector, Scraper bar & skid shoes – Briggs & Stratton 1732 User Manual

Page 19

Advertising
background image

17

Figure 7. Skid Shoe Adjustment
A. Scraper Bar
B. Skid Shoe
C. Nuts

Figure 5. Chute Deflector Adjustment (Some Models)
A. Chute Deflector Knob
B. Chute Deflector

Figure 6. Remote Deflector Control (Some Models)
A. Maximum Throwing Position
B. Spring
C. Control Handle

A

C

A

A

B

C

B

B

DEFLECTOR

The distance of the discharged snow is mainly controlled
by the position of the deflector. (Engine speed also
affects distance of discharge.) The more the deflector is
tilted UP, the farther snow will be thrown.

Models with Chute Deflector Knob

See Figure 5.

1. Loosen the deflector knob, tilt the deflector UP or

DOWN.

2. Retighten the knob when desired angle has been

chosen.

Models with Remote Deflector Control

See Figure 6.

1. Turn the remote deflector control (C) counterclock-

wise to UNLOCK, and the spring (B) will pull the
deflector to the maximum throwing position (A). Pull
the knob UP to decrease the throwing distance.

2. Turn the remote deflector control knob clockwise to

LOCK in place when the desired angle has been cho-
sen.

SCRAPER BAR & SKID SHOES

On smooth surfaces such as concrete or asphalt, the
scraper bar (A, Figure 7) should scrape the surface. On
surfaces such as gravel, the scraper bar should be high
enough so that it will not pick up gravel or debris.

The height of the scraper bar (A) is controlled by raising
or lowering the skid shoes (B).

1. To raise the scraper bar height, rest the scraper bar

(A) on a strip of wood equal in thickness to the desired
height.

2. Make sure the scraper bar is parallel to the ground

surface.

3. Loosen the skid shoe nuts (C) and let the skid shoes

(B) drop to the surface.

4. Tighten the nuts (C), making sure the skid shoes are

adjusted equally and are parallel to the surface.

5. To lower the height of the scraper bar, raise the skid

shoes. Or adjust scraper bar by loosening the attach-
ment bolts and sliding scraper bar down.

6. If the scraper bar becomes worn, it can be replaced

by removing the hardware attaching it to the
snowthrower.

Operation

Advertising
This manual is related to the following products: