Blaupunkt BERGAMO RCR 148 - Manual (Page 16)

37
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
FOLK MUSIC
DOCUMENTARY
ALARM TEST (for service only)
Checking the programme type of the
station
• Press PTY for approximately 1 sec.
After the beep tone the display will show the
programme type offered by the tuned in sta-
tion.
If “NONE” appears in the display, the cur-
rent station has no PTY code.
Displaying the selected programme
type
• Press << or >>.
The programme type selected last will be
displayed briefly.
Selecting a programme type
a) Using the preset buttons
When PTY is switched on, you can use
the preset buttons 1-6 to select the
programme types stored at the factory.
• Press one of the presets 1-6.
The selected programme type will be
displayed for 2 seconds.
If you wish to listen to a station with
this PTY,
• press / to start seek tuning.
If the system is unable to find a station of-
fering the selected programme type, the dis-
play will show “NO PTY” and a beep tone
will be released. The station received be-
fore starting seek tuning will be tuned in.
You can assign different programme types
to each preset position. Please refer to chap-
ter “Storing programme types”.
b) Using the << >> buttons of the rocker
switch
When PTY is switched on, you can se-
lect a programme type using buttons
<< >>.
• Press << or >>; the programme
type selected last will be displayed
for 3 seconds.
• During this period press >> (for-
wards) or << (backwards) to select
the desired type.
• Press << or >> as many times as
required.
If you wish to listen to a station offering
the selected PTY,
• press / to start seek tuning.
If the system is unable to find a station of-
fering the selected programme type, the dis-
play will show “NO PTY” and a beep tone
will be released. The station received be-
fore starting seek tuning will be tuned in.
Storing programme types
At the factory, one programme type was
assigned to each of the preset buttons 1-6.
If desired, you can also store other availa-
ble programme types.
To do so, make sure that “PTY” lights up in
the display.
•
If necessary, press the PTY button to
switch on the function.
• Select a programme type using but-
tons << >> and
• hold down the desired preset button
(1-6) until you hear a beep.
Now the selected programme type can be
recalled by pressing this preset. For this, the
PTY function must be active.
Scanning stations with PTY-SCAN
Condition: “PTY” must appear in the display.
• Press the SC button.
All of the received stations offering the se-
lected programme type will be scanned.
To switch off PTY-SCAN:
•
Press SC once again.
Ber/Mon/WiRCR148 gb 08.05.2002, 11:42 Uhr 37