InnoMax Adjustable Bed Base - Manual (Page 9)

PowerBASE™ Owners Manual 99300787-i
9
insTallaTiOn
Note: if adjustable bed is to be set up
without a headboard, basic installation
is now complete. If headboard is to be
installed, proceed to Headboard Bracket
Installation.
standard Mattress retainer
10. Install mattress retainer at the foot end of
the bed base as follows:
Note: for Profile-DC model adjustable bed
mattress retainer installation, refer to Step
10a installation instructions. For tooless
model adjustable bed mattress retainer
installation, refer to Step 10b installation
instructions.
a. Install (1) cupped washer, (1) spacer
and (1) flat washer on (4) mattress
retainer bolts (
FIGurE 4).
fiGure 4: standard mattress retainer hardware.
MaTTress reTainer Hardware
kiT COnTains:
(4) MaTTress reTainer BOlTs -
a
(4) flaT wasHers - B
(4) spaCers - C
(4) Cupped wasHers - D
flaT
wasHer MaTTress
reTainer
BOlT
spaCer
Cupped
wasHer
a
B
C
d
assemble as
shown:
b. Install the mattress retainer bolts
(loosely) into (4) threaded lugs in the
top side of the bed base at the foot
section (
FIGurE 5).
c. Slide each U-shaped end of the
mattress retainer around the
mattress retainer bolts. Position
the retainer ends with the cupped
washers on top (
FIGurE 5).
sTandard
MaTTress
reTainer
flaT wasHers fiT
BeTween THe Bed
Base fraMe and THe
MaTTress reTainer
(2) THreaded luGs in
eaCH side Of THe
Bed fOOT seCTiOn
Cupped
wasHers
fiGure 5: standard mattress retainer installation.
fiGure 6: standard mattress retainer installed.
d. Tighten screws to complete mattress
retainer installation ( FIGurE 6).
dO nOT use pOwer sCrewdriver TO
insTall MaTTress reTainer.
DO NOT
OvErTIGHTEN MaTTrESS rETaINEr
HarDwarE!
NOTE