Bissell 30C7 - Manual (Page 13)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
13
M
aintenance and care
you should check your vacuum
cleaner’s rotating floor brush and
drive belt regularly for wear and
damage. you should also clean the
brush and brush ends of strings,
hair, and carpet fibers. this type of
debris can wrap around the brush
and hamper its ability to effectively
clean your carpet. also remove any
debris that has accumulated under
the brush cover.
1. U nplug the vacuum from electrical outlet.
2. Place handle in low position and turn
vacuum cleaner over so bottom side is fac-
ing up.
3. Remove the six screws on the sole plate
with a Phillips head screwdriver. Lift the
brush cover off.
4. Grasp rotating floor brush at both ends
and lift.
5. Clean string, hair, and other debris from
rotating floor brush, paying particular
attention to brush ends.
6. Check air passageway for obstructions.
Remove any debris from this area.
7. Clean debris from the motor pulley and
drive belt areas.
8. Check drive belt carefully for wear, cuts, or
stressed areas. If any damage is present,
discard old drive belt and replace, see
page 14.
check rotating floor brush and drive belt
3
4