Steele Products SP-PT212 - Manual (Page 8)

Reciprocating Saw
8
Rear Handle Adjustment :
The rear handle of this tool can be rotated around the main body of motor and locked at five
different angles so that you can operate the tool at most comfortable postion.
Pull the rear handle release button back to unlock the rear handle. Turn the rear handle to desired
angle and release the rear handle release button. Turn the rear handle left or right so that it locks
at the nearest preset position with a lear click.
Switching on and off
Caution! Ensure that the tool is in good condition.
The trigger switch of this tool features variable speed control:
1. switching on/off: plug the cord set into the power socket. Slowly depress the trigger switch,
the tool will be turned on and runs from slow to fast. The tool reaches its full speed when the
trigger switch is fully depressed. Fully release the trigger switch will turn the tool off.
2. continuous running: depress the lock-on button after the trigger switch is fully depressed,
then release the trigger switch, the tool will be under continuous running status. To stop the
tool, fully depress the trigger switch and the lock-on button will spring up back to its original
position, release the trigger switch.
General Cutting
1. Make sure the saw blade is clear of any foreign material and the power cord or extension cord are
out of the path of the blade.
2. Be sure the material to be cut is held firmly. Small work pieces should be securely clamped in a
vise or clamped to the work bench.
3. Make out a cutting line.
4. Hold the saw firmly in front and clearly away from you.
5. Switch on the tool and wait until the saw has reached its full speed.
6. Place the shoe on the work piece and begin to saw.
OPERATION