Steele Products SP-PT253 - Manual (Page 13)

Owner’s Manual
13
Operation (cont’d)
Inserting/Removing Accessories
To loosen the collet nut:
1 Press the shaft lock button.
2 Rotate the shaft manually until the
lock engages and prevents further
rotation.
3 Use the wrench to loosen the collet
nut by turning in the direction of the
arrow labeled L in the illustration. The collet nut must be loose in order
to insert or remove accessories.
4 Remove the old accessory (if any) and install the new accessory, being
sure to push it as far as possible into the collet.
5 Tighten the collet nut
by hand until snug.
6 Finish tightening the
collet by turning the
wrench in the direction
of the arrow labeled T
in the illustration. Do
not overtighten.
WARNING! ALWAYS UNPLUG THE ROTARY TOOL BEFORE
CHANGING ACCESSORIES/COLLETS OR SERVICING YOUR TOOL THE
TOOL COULD START UNEXPECTEDLY, CAUSING SERIOUS INJURY.
CAUTION: DO NOT ATTEMPT
TO ENGAGE THE SHAFT
LOCK WHILE THE TOOL IS
RUNNING.
:5(1&+
6+$)7
/2&.
%87721
&2//(7
&2//(7
187