Steele Products SP-GG120CM - Manual (Page 17)

16
Owner’s Manual
Operation
NOTE: THE PARTS LISTED ABOVE ARE HELPFUL FOR LOCATING THE
CONTROLS MENTIONED BELOW.
CAUTION: PRIOR TO FIRST USING THE GENERATOR, THE ENGINE MUST BE
FILLED WITH OIL OF A HIGH QUALITY SAE
(10W-30)
GRADE ENGINE OIL.
TO DO SO, UNSCREW AND REMOVE THE ENGINE’S OIL DIPSTICK LOCATED
AT THE BOTTOM OF THE ENGINE CRANKCASE. FILL THE ENGINE’S
CRANKCASE UNTIL THE OIL LEVEL IS LEVEL WITH THE UPPER MARKED
LINE ON THE DIPSTICK. THEN SCREW THE DIPSTICK BACK INTO
THE OIL FILL HOLE.
Pull Start
Pull Start: Manual start.
Oil Fill: To check and fill oil. (10W-30 Grade Engine Oil)
Outlets: Plugs for appliances, etc.
Circuit Breaker: Breaker for outlets incase of overloads.
DC Output: Used for charging batteries only.
Choke: Used for cold starting the generator.
Fuel Valve: To allow fuel to the engine.
Choke
AC 120V
PILOT
OFF
CIRCUIT BREAKER DC
CIRCUIT BREAKE
R AC
ON
ENGINE SWIT
CH
PUSH TO RESET
Fuel Valve
Outlet
Oil Fill
DC Output
Fuel Tank