Steele Products SP-GG750E - Manual (Page 10)

Owner’s Manual
9
General Precautions
When servicing a generator, use only identical replacement parts. Follow all appropriate instructions in this
manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric
shock or injury.
Heart Pacemakers
WARNING! People with pacemakers should consult their physician(s) before using this product.
Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the
pacemaker.
Installation
Ensure installation meets all applicable safety, and local and national electrical codes. Have installation
performed by a qualified, licensed electrician and building contractor.
All electrical work, including the earth-ground connection, should be completed by a licensed electrician.
Any separate fuel storage or generator supply facility must be built or installed in full compliance with all
relevant local, state, and federal regulations.
If the generator is installed outdoors, it must be weatherproofed and should be soundproofed. It should not
be run outdoors without protection to the generator and wiring conduit.
The generator weighs 195 lbs. Two or more people should assist when moving or lifting this product. Never
lift the generator using the engine or alternator lifting lugs. Connect lifting equipment to the frame of the
generator.
Before lifting the generator, ensure the lift rigging and supporting structure are in good condition, and are
rated to lift such a load.
Keep all personnel away from the suspended generator during relocating.
The supporting floor/ground surface should be level and strong enough to safely hold the weight of the
generator. If the floor/grounded surface is not level, strong cross members should be placed under the full
length of the generator frame at its low side.
For trailer installation, the generator should be mounted on the center point of the trailer, over the wheels.
The trailer must be capable of supporting the weight of the generator and all contents (tools, etc.)
Install sound-and weather-proofing only when it is not raining or snowing to avoid trapping moisture within
the generator’s area.
Mechanical
Always make sure the power switch is in its “OFF” position. Disconnect the spark plug wire, and allow the
engine to completely cool before carrying out maintenance.