Steele Products SP-HD916 - Manual (Page 4)

4
Owner’s Manual
Operation
1. The timer is the main switch, please turn it to the “ON” position if you want it to work
continually.
2. If you want a certain timing period, you can set the timer at any time from 0 to 120
minutes.
3. The unit will stop working if the timer is turned to the “OFF” position.
4. If you want the minimum power, turn to the “500W” position.
5. If you the maximum power, turn to the “1000W” position.
6. If you want the oscillating feature, please turn to “500W/oscillation ” or
“1000W/oscillation”.
7. If you want to adjust the unit up, press the “PUSH” button.
8. If you want to adjust the height, then press the plastic back cover of the head.
9. The unit can be oscillated vertically within an angel of 40 degree.
After use, rotate the power/timer knob to the “OFF” position and unplug the plug.
Cleaning/Maintenance/Storage
1. Make sure to switch off the power supply and pull out the plug before cleaning.
2. The reflector body can be cleaned with a soft damp cloth, using a small quantity of
mild detergent, make sure not to splash water on the lamps. Never use solutions such
as benzene, thinners or polishing agents. In order to maximize heat output, the reflector
must be kept clean.
3. The main body of the heater can be cleaned with a soft damp cloth, using mild
detergent. After cleaning, wipe with a dry cloth.
4. After cleaning, make sure the heater is thoroughly dry, and then reassemble.
5. When the heater is not in use, place in a sealed plastic bag and store in a dry place.
The heater can be packed again according to its packing method.
Electrical Ratings:
Item No:
SP-HD916
Voltage 120 V
Frequency 60Hz
Power 500W/1000W
(2 heat settings)