Owner’s manual – Steele Products SP-HO74 User Manual
Page 3
CAUTION:
THIS APPLIANCE HAS A POLARIZED PLUG (ONE BLADE IS WIDER THAN THE OTHER) TO
REDUCE THE RISK OF ELECTRIC SHOCK. THIS PLUG IS INTENDED TO FIT IN A POLARIZED OUTLET
ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN THE OUTLET, REVERSE THE PLUG. IF IT STILL
DOES NOT FIT, CONTACT A QUALIFIED ELECTRICIAN. DO NOT ATTEMPT TO DEFEAT THIS SAFETY
FEATURE.
ASSEMBLE
The heater is packaged with the feet unattached. You must attach them before operating the heater.
1. Place the radiator body upside-down on a scratch-free location, make sure it is stable and will not fall.
2. Screw off the wing nuts from the U-shaped bolt provided, attach the U-shaped bolt to the U-facing flange
between the last 2 fins.
Figure 2
3. To attach the castor mounting plate to the radiator body, you should insert the threaded ends of the U bolt
in the holes on the castor mounting plate.
4. Screw the wing nuts back to the U bolt and fasten the wing nut properly.
See figure 2
Note: do not over tighten, which may cause the damage of radiator flange.
Screw off spherical nut from the castor, align the shaft to the hole of the castor mounting plate, insert in,
and screw on the spherical nut. See figure 2
6. Turn the heater upright.
5.
Now your heater is ready for use
Note: the rear castors must be mounted between the end two fins.
CAUTION-
Risk of fire-Do not operate without legs attached.
CAUTION-
Operate the heater in upright position only (wheels on the bottom; controls on the top).Any
other position could create a hazardous situation.
OPERATION
1. LOCATION
Before using the heater make sure that it is on a flat and stable surface. Damage may occur if it is placed on
an incline or decline.
Place heater on floor beneath coldest window in the room or any desired location. Your heater will minimize
3
Owner’s Manual
the effect of cold drafts.
2. CONNECTION
The radiator must be connected to a properly household outlet in perfect working conditions.
Keep loose clothing or bedding, furniture and flammable material away from the wall outlet where the heater
plug is fitted in.