Steele Products SP-HO74 - Manual (Page 4)

3. INSTRUCTIONS FOR USE
4
Owner’s Manual
NOTE:
This heater includes an overheat protection system that shuts off the heater when parts of the heater are
getting excessively hot. Once it occurs, the heater’s programs will be lost.
To completely shut the heater off, set the button “power setting” to OFF, then remove plug from the
socket-outlet.
1. Before using the heater make sure that it is on a flat nd stable surface.Damage may occur if it is placed on
an incline or decline.The supply cord should be unwind completely before operation.
POWER SUPPLY CORD
Plug the power supply cord into a wall outlet (120V AC 60Hz).
This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug.
MAINTENANCE
1. Always remove the plug from the power socket and allow the radiator to cool down. Wipe radiator with a
soft damp (not wet) cloth. Do not use detergents and abrasives. Do not allow the interior to get wet as
this could create a hazard.
2. To store away the heater, wind the cable around the cord bobbin, and store in a clean dry place.
3. This appliance has been built to give many years of trouble-free service. In case of malfunction of doubt,
do not try to repair the radiator yourself; it may results in a fire hazard of electric shock. Call the nearest
Service Center.
2. Set all the controls to OFF position.and insert the plug into a socket-outlet with well grounded.
Be sure plug fits tightly into outlet.
3. Rotate the thermostat knob clockwise to maximum position and switch the heater on as follow:
the switch I for low heat.the switch ll for medium heat.and the switch lll for high heat.
4. When your room reaches the desired temperature.now slowly rotate the themostat knob
counter clockwise until hear a click.The thermostat can now be left at this setting.As soon as the
room temperature has dropped below the set temperature.the unit will switch itself on
automatically until the set temperature has been reached again.In this way the room temperature
remains constant with the most economical use of electricity.
5. If you want to change the room remperature setting.rotate the themostat knob clockwise to
raise the temperature.or counter clockwise to lower it.
6. If this heater is designed to automatically shut-off when tipped left or right.When returned to
normal upright position.heat will automatically come on again.This is a safety feature to avoid
possibility of fire should the unit be accidentally upset.
7. This heater includes an overheat protection system that shuts off the heater when parts of the
heater are getting excessively hot.
8. To completely shut the heater off.turn all the controls to OFF.and remove plug from the
socket-outlet.
MAINTENANCE
1. Always remove the plug from the socket-outlet and allow the radiator to cool down before clean
the heater.
2. Wipe radiator with a soft damp (not wet) cloth.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives. Do not allow the
interior to get wet as this could create a hazard.
3. To store away the heater.wind the cable onto the bobbin.and store the heater in a clean dry
place.
4. In case of malfunction or doubt.do not try to repair the radiator yourself.it may resuit in a fire
hazard or electric shock.