Steele Products SP-GM655 User Manual
Page 2
12. PROTECT YOUR HEARING. Wear hearing protection during operation.
13. DON’T OVEREACH. Keep proper footing and balance at all times.
Do not use tool on an unstable support.
14. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and safer performance.
Follow instructions for lubricating and changing accessories.
15. REMOVE ADJUSTING KEYS AND WRENCHES. Form a habit of checking to see that keys and
adjusting wrenches are removed from tool before turning it on.
16. NEVER USE IN AN EXPLOSIVE ATMOSPHERE. Normal sparking of the motor could ignite fumes.
17. KEEP HANDLES DRY, CLEAN AND FREE OF OIL AND GREASE. Always use a clean cloth when
cleaning. Never use break fluids, gasoline, petroleum based products or any strong solvents
to clean you tool.
18. STAY ALERT AND EXERCISE CONTROL. Watch what you are doing and use common sense.
Do not rush.
19. CHECK DAMAGED PARTS. Before further use of the tool a guard or any other part that is
damaged should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment of moving parts, binding of moving parts, breakage of
parts, mounting and any other conditions that may affect its operation. A guard or any other
part that is damaged should be properly repaired or replaced by an authorized service center.
20. DO NOT USE TOOL IF SWITCH DOES NOT TURN IT ON AND OFF.
Have defective switches replaced by authorized service center.
21. DO NOT OPERATE THIS TOOL WHILE UNDER THE INFLUENCE OF DRUGS, ALCOHOL OR ANY
MEDICATIONS.
2
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
Due to continued product refinement policy, product features and specifications can and will
change without notice.Check current features and specifications with your retailer.
ASSEMBLE FRAME & WHEELS
Align the holes in the wheels to the holes in the axle section of the frame and secure tightly with the
bolts, spring washers and nuts provided as shown in Fig. 1.
Affix the hub caps to the wheels. Fig. 2
TOP HOPPER
Place the Top Hopper onto the metal feed tube and align the attaching holes.
Secure the one way screw.Fig. 3
3