Steele Products SP-GM655 - Manual (Page 3)

HANDLE
Insert the handle bar into the handle shafts located at the rear of the machine. Align the holes in the
handle bar to the holes in the handle shafts and secure with the 2 knobs as shown in Fig. 4 & 5.
SAFTEY SWITCH
The safety switch that is located on the cutter base is activated when the
Top Hopper assembly is removed to help prevent accidental starting. Fig. 6
4
OPERATION
Read and understand the safety instructions in this owner’s manual before using your STEELE®
SHREDDER. Connect the machine to a suitable power outlet.
To start the machine, place the On/Off switch located at the rear of the motor to “ON” position.
Fig. 7. To stop the machine, switch to the “OFF” position.
ATTACHING MULCH BAG
Place a heavy duty garbage bag over the lip of the discharge chute and secure into position using
a strap. Fig. 8
MAINTENANCE
Your STEELE® SHREDDER has been designed for a low level of maintenance, involving routine
cleaning and inspection. The motor of the machine is maintenance free and requires no attention.
For best results the blades must be kept sharp at all times. The blades have dramatically less
cutting power when dull. The machine will tear rather than cut when the blades are dull. When this
occurs rotate the double sided blades or replace the blades immediately.
WARNING
Before attempting any maintenance, switch the machine off and disconnect the power cord from
power source.
JAMMING
If blades become jammed, switch off the machine and disconnect the power cord from the power
source. Always wear gloves when attempting maintenance of the cutting chamber. Unscrew the 3
securing Top Hopper assembly knobs. Remove the Top Hopper assembly and remove the
obstruction from the cutting chamber.
WARNING
Take extreme care not to come in contact with cutting blades. Assemble the Top Hopper in reverse
order stated above.
5