Steele Products SP-GMK049 - Manual (Page 12)

(20) Store the power drill off the ground, in a vertical position and in a
dry place. Make sure the fuel tank is empty.
(21) Check the power drill each day to ensure that each component is
functional.
(22) While working and moving from one work area to another make sure
the engine is on the idle position.
(23) Never use a damaged, modified, or improperly repaired or
assembled power drill. Do not remove or dis-activate any of the safety
features. Only use bits that are specifically made for this machine.
(24) Never touch the spark plug cover or wire while the engine is in
operation. Doing so could result in electrical shock.
(25) Do not use the power drill until you have completely understood this
operating manual. Always follow the manufacturer’s instructions for
maintenance and operation.
(26)After the engine starts or before it stops, allow it run 2~3 minutes at
a low speed without any load. Do not run it at a full throttle. Never stop
the engine at high speed.
(27) After engine starts, never touch the muffler and the cylinder. Doing so
could result in serious burns.
(28) If your power drill is no longer usable, disposed of it properly without
indangering the environment.
(29) All service, other than the operations shown in the present manual,
should be performed by a service technician.
(30) Keep this manual on hand.
(31) Check, adjust, repair and clean the machine regularly. When
replacing parts, please use the tools specified by our company.
(32) Do not use this tool for any other applications that it is not intended
for.
10