Steele Products SP-PM207DC - Manual (Page 15)

OPERATION YOUR MOWER
15
CHARGING PROCEDURE
Note: The battery can be charged in or out of the mower.
The charger that is supplied with this mower is a specially designed 2-stage charger.
Step 1: The red light will light up during the recharge cycle.
Step 2: The green light will light up when the battery is fully charged.
1. Remove the jack cover.
2. Plug the charger connector into the jack on the battery.
3. Insert the 120 V plug from the charger into the electrical outlet.
4. The red light on the charger should come on, which indicates that the charger is working and the
battery is being charged. The red light will go out and the green light will come on when the battery
is completely charged (it takes approximately 15 hours to charge a fully discharged battery).
REMOVING BATTERY INSTALLING BATTERY
Push battery down
to limit chute Laminated both
after rotaing
Level two rails Slide into the
pole position
Pull up the
battery pack Rotation and bring lift battery
4
WARNING :Do not store battery in temperatures lower than 32°F (0°C)
BATTERY USE
NOTE: If the switch does not reengage or the mower does not run
whenthe battery is installed.
Push the Battery Capacity Indicator (BCI) switch, which is located on
the back of the battery. The lights will indicate the battery's capacity,
according the following chart.
Green Green Green Yellow Red
BCI switch
Lights
3 Green Lights
2 Green Lights
1 Green Light
Yellow Light
Red Light
The battery is at full capacity
The battery is at 60% capacity
The battery is at 50% capacity
The battery is at 40% capacity and
requires charging soon
The battery is at 20% capacity and
requires charging
capacity