BNC 1420 - Video Microscope User Manual
Page 18
16
Removing the illumination module
Note:
When reinserting the illuminator module take care that the
connector pins are all correctly inserted in the receptacle
without bending or damaging the pins. Also take care not to
apply excessive force. Support the camera module from below
with your hand when inserting the illumination module and
press from below to ensure the traverse mechanism is
magnetically seated.
2.8
Base stand
The Model 1420 is delivered with four rubber feet attached with 8-32
screws on a 7.00 × 9.00 rectangle to place the instrument on a plane
table surface. The feet can be replaced by leveling feet which allow fine
adjustment of the instrument or standard optical posts which can be
clamped firmly to an optical table. Contact BNC for more information.