Poison Spyder CJ FULL WIDTH CONVERSION KIT - Manual (Page 5)

INSTALLATION INSTRUC
TIO
NS
©2009 POISON SPYDER CUSTOMS, INC. • 951-849-5911 • WWW.POISONSPYDER.COM
FIGURE 15
This kit is designed to accept a 2-1/2” wide
spring, but a stock CJ 2” spring can be
used. If using a 2” spring, you will need to
use washers or spacers totalling 1/4” thick
on either side of the spring eye, between the
spring and the bracket. You would also need
to use a stock CJ front shackle hanger.
FIGURE 16
WARRANTY
Poison Spyder Customs™ warranties all of
the products we sell and distribute for one (1)
year from the date of sale. These products will be
free from defects in material and workmanship
under normal installation, and use. Due to the
intended use the powder coat finish is warranted
for ninety (90) days. The finish warranty will not
cover a product if it has been damaged in any
way. Warranty is limited to repair or replacement.
Poison Spyder Customs™ does not offer any
type of labor or shipping allowance and all
warranty claims are subject to inspection by
Poison Spyder Customs™.
At the discretion of Poison Spyder Customs™,
the products in question can be repaired or
replaced when found defective. Prior to any
replacement or repair, written authorization must
be obtained from Poison Spyder Customs™.
Failure to contact us prior to having warranty work
preformed will immediately void all applicable
warranties; and it is then the sole responsibility
of the customer to remit any payment incurred.
The warranty expressed above is the sole
warranty of Poison Spyder Customs™, and
any other expressed or implied warranties are
hereby specifically excluded and disclaimed.
HOLD HARMLESS AGREEMENT
1. In purchasing a Poison Spyder Customs
Product™ I release, waive, discharge and
covenant not to sue Poison Spyder Customs
officers, servants, agents, or employees
(hereinafter referred to as Releasees) from
any and all liability, claims, demands, actions
and causes of action whatsoever arising out
of or related to any loss, damage, or injury,
including death, that may be sustained by
me (or anyone else), any property belonging
to me (or anyone else), whether caused by
the negligence of the releasees or otherwise,
while working on, using or any activity related
to this product.
2. I am fully aware of risks and hazards connected
with the use of a this product and I elect to
voluntarily engage in such use of this product
knowing that the use may be hazardous to
me and my property. I voluntarily assume full
responsibility for any risks of loss, property
damage or personal injury, including death,
that may be sustained by me (or anyone
else), or any loss or damage to property
owned by me (or anyone else), as a result
of using this product, whether caused by the
negligence of releasees or otherwise.
3. I further agree to indemnify and hold harmless
the releasees from any loss, liability, damage
or costs, including court cost and attorney
fees, that they may incur due to my use of a
this product, whether caused by negligence
of releasees or otherwise.
4. It is my express intent that this Release and
Hold Harmless Agreement shall bind the
members of my family and spouse, if I am
alive, and my heirs assigns and personal
representative, if I am deceased, and shall
be deemed as a release, waiver, discharge,
and covenant not to sue the above named
Poison Spyder Customs • CJ FULL WIDTH FRONT AXLE CONVERSION Page 5