SkyTrak 8042 Operation Manual - Manual (Page 112)

110 Model 8042 Rev. 11/03
General Maintenance
Lubricate the following grease
fittings using
Multi-Purpose Grease (MPG):
A. Carriage pivot pins.......................................... (2 points)
B. Attachment tilt cylinder pins .......................... (2 points)
C. Boom attachments .......................................... (all points)
D. Extend Chain Sheave...................................... (1 point)
E. Retract Chain Sheave ..................................... (1 point)
Lubricate the following grease
fittings using
Multi-Purpose Grease (MPG):
F. Hydraulic cylinder pins................................... (12 points)
G. Drive shaft slip joints ...................................... (3 points)
H. Boom pivot pin ................................................ (2 points)
I. Axle U-Joints ................................................... (8 points)
J. Axle pivot pins................................................. (2 points)
Lubricate the following grease
fittings using
Multi-Purpose Grease (MPG):
K. Extend cylinder pins ....................................... (2 points)
NOTE: Shorten the lubrication interval on all lube points when operating in
severe conditions.
1. Lubrication Points
OS1750
50
OH2680
250
OH2710
OS1750
1000
OH2690
OS1750