SkyTrak 8042 Operation Manual - Manual (Page 51)

Operation
49 Model 8042 Rev. 11/03
Turn Signals
The directional signals are ACTIVATED from the lever (2) on the right side
of the steering wheel and will only operate when the ignition switch is in the
RUN position.
To activate the left turn signal (3), raise the lever. To activate the right turn
signal (4), lower the lever. To deactivate either directional signal, the lever
must be manually returned to the center position. The lever will not cancel
automatically after a turn.
Parking Lights, Headlights & High/Low Beam Switch
With the ignition switch in the RUN position use the turn signal switch to
control the high/low beam headlights, turn on the parking lights and the
headlights. Turn the twist grip end of the turn signal switch counter-
clockwise to the first position (5) to turn the parking lights ON. Turn the twist
grip to the second position (6) to turn the headlights and parking lights ON.
Turn the twist grip clockwise to the OFF position (7) to turn all the lights
OFF. Pull the turn signal switch toward you to switch from low beam to high
beam. When the high beam is ON the high beam indicator light will
illuminate.
OH2510
OH3330
3
4
7
6
5
2