Hyline Offroad JK TUBE STEP ROCKER PANELS (2 DOOR MODELS) - Manual (Page 3)

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.110-JK ROCK SLIDER (2 DOOR)\400.300.110 Installation Instructions.doc Page 3 of 4
REV 1 1/21/14
7. Now install the supplied 3/8-16 Threaded U-Bolts by inserting one end first, then feeding and turning the U-Bolt
until you fish it out the other hole. Do this before installing the Rock Sliders. Press on the provided Retaining Rings
immediately after the U-Bolt is installed to prevent from slipping into frame. (Figure 2)
8. Now you’re ready to install the Rock Slider (Much easier with two people).
Slide the Rock Slider Brackets between the skid plate mounts and frame rail
and install the two original bolts into the bottom.
DO NOT TIGHTEN YET.
9. Fasten the 3/8-16 Hex Nuts onto U-Bolts with flat washers and lock washers.
Do Not Overtighten These Nuts.
10. Tighten two bolts on the bottom of the frame.
11. The installation of the Passenger Side Rock Slider is now complete.
Driver Side Installation:
12. Remove the existing bolts from under frame rail, similar to passenger side.
13. Insert the Driver Side steel drill template (RED Dot) between skid
plate crossmember and the frame rail. Re-install the two bolts you previously
removed to fasten template tight to frame.
Figure 2, Install U-Bolt by inserting one
leg first as shown.
Figure 3 – U-Bolts Installed & Fastened
Helpful Tip When Installing the Retaining Rings: Once you have the U-Bolt
in the frame, install a washer and nut on one side of the U-Bolt. This will
hold U-Bolt in place and make placing the retainer ring on U-Bolt easier.