Hyline Offroad JK TUBE STEP ROCKER PANELS (4 DOOR MODELS) - Manual (Page 3)

Q:\Hyline Offroad, LLC\Installation Instructions\400.300.100-JK TUBE STEP ROCKER 4 DOOR\400.300.100 Installation Instructions.doc Page 3 of 4
REV 1 04/16/13
7. Now install the supplied 3/8-16 Threaded U-Bolts by inserting one end first, then feeding and turning the U-Bolt
until you fish it out the other hole. Do this before installing the Rock Sliders. Press on the provided Retaining Rings
immediately after the U-Bolt is installed to prevent from slipping into frame. (Figure 2)
8. Now you’re ready to install the Rock Slider (Much easier with two people).
Slide the Rock Slider Brackets between the skid plate mounts and frame rail
and install the two stock bolts into the bottom. Also install the supplied M12
bolt with lock washer & flat washer in forward most hole.
DO NOT TIGHTEN YET.
9. Fasten the 3/8-16 Hex Nuts onto U-Bolts with flat washers and lock washers.
Do Not Overtighten These Nuts.
10. Tighten all other bolts on the bottom of the frame.
11. The installation of the Passenger Side Rock Slider is now complete.
Driver Side Installation:
12. Remove the existing bolt from underside of frame rail. This bolt will
be in the center of the frame rail.
13. Insert the Driver Side steel drill template (RED Dot) between skid
plate crossmember and the frame rail. Hold up the template and install
one of the supplied M12 bolt and flat washer into the forward most hole.
Then re-install the other bolt you previously removed. The Driver
Side does not have an existing hole for the rear most location. There is
a hole in the template where you’ll need to drill.
Figure 2, U-Bolt Shown without Rock
Slider For Clarity. Install with Rock
Slider In Place
Figure 3 – U-Bolts Installed & Fastened