Figure 4, Figure 5 – Hyline Offroad JK SERIES TIRE CARRIER READY REAR BUMPER User Manual
Page 3
Install Hyline Offroad Rear Bumper
Step 5 – Slide the Inner Frame Mounting Brackets inside each
frame rail. Position the bracket so that the weld nuts
are centered with the large slotted holes in the side frame.
(See Figure 4)
Step 6 – Now you’re ready to slide the Hyline Rear Bumper in place. Guide the bumper mounting
brackets that are welded onto the bumper over top of the frame rails. Push the bumper onto the Jeep
until the holes in the bumper mounting brackets are aligned with the holes in the frame.
Step 7 – Using the supplied ½-13 Grade 8 Bolts, Lock Washers
and Flat Washers along with the 4 metric bolts you took
out in Step 1, thread each bolt into it’s respective hole.
(See Figure 5)
Step 8 – Once all the bolts have been hand tightened you can now
Tighten ½-13 Bolts with the ¾” socket (100 ft/lb) and
other bolts with 16mm socket (50 ft/lb).
Step 9 – After about 50-100 miles of driving re-check all bolts and
torque to proper settings.
T:\Hyline Offroad, LLC\Installation Instructions\JK-20SRB\JK-20SRB Installation Instructions.doc
Page 3 of 4
REV 1 3/17/2010
Figure 4
Figure 5