Hornady RAPid Safe - Manual (Page 5)

Choose the two RFID entry methods (tags)
you prefer, and program them for use.
Program Buttons
5
RFID Tags
Your RAPiD ™ safe includes five (5) different
RFID tags, including:
• 3 Bracelets ( M, L, XL)
• 1 Key Fob
• 1 Card
The safe’s system can only store up to two (2)
different tags at a time. Only two tags can be
programmed for use. The remaining three tags
will be inert, but can be circulated as one of
the programmed tags if you choose to use
them later, i.e., you can program two bracelets,
or one bracelet and the card, but no more than
two tags may be programmed for use at any
given time.
How To Change Your RFID Tags
The RAPiD ™ safe can store up to 2 tags.
To program these tags:
1. Open your RAPiD
™ safe.
2. Locate the three small program buttons on
the inside right corner.
3. Press the middle (black) button to program
your FIRST RFID tag. Choose one of the five
tags listed above.
4. When the amber status light on the keypad
blinks, the system is ready for your RFID tag.
5. Place the RFID tag approximately 1/2" over
the RFID reader (H logo) that is located on
the front panel of the safe.
6. Wait for the status light to display green.
7. Remove the tag from the RFID reader on the
front panel of the safe.
8. WITH THE LID OPEN, test the tag by placing
it approximately 1/2" over the RFID reader. If
you do not hear and see the motor activate,
repeat steps 2 through 8.
9. The second RFID tag can be programmed
by pushing the third, lowest (black) button
inside the box and following the steps above.