Bowens QUAD2400 - Manual (Page 3)

Introduction
Safety Notes
3 10
DO NOT:
• Use in an environment where moisture or flammable vapor is likely to come in contact with the
pack or the flash heads.
• Plug or unplug flash heads without first switching power off.
• Restrict air vents while in use.
• Use a unit with damaged housing, moldings, flash tube or modelling lamp.
If the unit is dropped or damaged in any way, always have it checked out before using.
• Operate the unit without a safe grounded AC supply.
DO:
• Switch power off and disconnect from the supply before changing modelling bulb or flash tube.
• Observe the AC power supply requirements.
• Ensure that the flash head cable locking rings at the power pack or adapters are fully
locked before use.
• Avoid placing cables where they can be tripped over. Protect from heavy, sharp or hot objects,
which may cause damage and replace damaged cables immediately.
• Unplug the power pack from the electrical outlet when not in use.
• Remove the power cord by gripping the plug. NEVER pull the cord.
• Ensure that any extension cord used has a suitable current rating to prevent overheating.
NEVER use coiled extension cords.
• ALWAYS remove the flash head covers before using.
Dear Valued Customer,
Thank you for choosing the Bowens QUAD2400 professional flash system.
Accurate, ergonomic, powerful and simple to use, the QUAD2400 power pack was designed by
working closely with photographers to develop a flash that meets the standards demanded in
professional studios today.
Heads and accessories from the QUAD range can be used with the QUAD2400 power packs. For
details of all related products, please contact your local distributor, a list of which can be found at
www.bowensinternational.com.
In order to obtain the full benefit from your purchase, please take a few moments to familiarise
yourself with this user manual.
Thank you.
Bowens International Ltd.
QUAD 2400
Number of Channels
Number of Head Sockets
Symmetric/Asymmetric
Master Power Control
Independent Channel Variators
Power Level Display
Flash Voltage Stabilization
Supply Voltage
Flash Ready Indication
Overload Protection
Sync Voltage (Max.)
Photocell
Audio Ready Signal
Modelling Lamps
Modelling Modes
Recommended Flash Head
Dimensions (l x w x h)
Stored Energy (Max.)
Flash Power Control Range
Typical Recycle Time
(Full Power)
Guide Number
(Full power, 50° Keylite, ISO 100)
Flash Duration (t=0.5)
(One Head, Max. Variator)
Flash Colour Temperature
Weight
www.bowens.co.uk www.bowens.co.uk