Hornady Lock-N-Load Control Panel - Manual (Page 3)

3
SETUP AND OPERATION
CONTROL PANEL SETUP (Deluxe & Standard models)
1) Align wire harness with
connector on back of the
Control Panel. Firmly press wire
harness into Control Panel while
supporting Control Panel.
2) Slide Control Panel Mounting
Bracket onto the Case
Feeder Tube.
3) Place Thumbscrew through
Control Panel Mounting Bracket
and tighten Thumbscrew.
NOTE: Do not overtighten
thumbscrew.
4) Plug 12V power supply into input
power jack on the wire harness.
OPERATION
• Press and hold POWER button to
power on the Control Panel.
• Press and hold POWER
button for 6 seconds to power
off the Control Panel.
• Press the POWER button
momentarily to reset the counter.
• Press MUTE button to silence
audible alarm (green light = un-
muted, and red light = muted).
NOTE: When the Control Panel is muted, the sensor lights will still turn from
green to red when a sensor is activated, but no audible alarm will be heard.
1
3
4
12V Output
Power
Jack
12V Output
Power
Jack
12V Input
Power Jack
Primer Slide Detect
Cycle Counter
Powder
Charge
Powder
Level
Primer
Level
Control Panel
Connector
WIRE HARNESS
REFERENCE VIEW
(not to scale)