Hornady Lock-N-Load Control Panel - Manual (Page 4)

4
COUNTER AND SLIDE DETECT SENSOR SETUP
(Deluxe & Standard models)
1) Verify reloading press is securely
mounted to bench with two bolts.
Remove the right bolt near the
primer feed/subplate, and insert
the bolt through the Counter
Bracket. Rotate the bracket until
the sensor levers align with the
subplate and primer slide.
NOTE: It is helpful to use the
Primer Follower to lock the Primer
Slide back to help set the Primer
Slide Switch.
2) Tighten the bracket down once
the Sensors are aligned.
3) Plug the wire harness into each
of the sensors using the two
white connectors near the 12V
input plug.
4) Verify the wire harness is
plugged in correctly by activating
the sensor and verifying the
corresponding light turns from
green to red (or the counter
increases by one).
NOTE: If the sensors do not
activate, the lever may be bent up
slightly by pressing down on the
lever near the housing and lifting
up on the end of the lever.
OPERATION
• Counter – When cycling the press (including fully returning the
handle as if seating a primer), the counter should increase with
each cycle.
• Primer Slide – When the primer slide is held back from either the Primer
Follower Rod dropping into the slide, or a jammed primer, the green
light on the Control Panel should turn to red at the bottom of the cycle.
1
3
2