PowerBridge LP3D - Manual (Page 2)

Step 2
PowerPanel Installation
A) Begin at the upper PowerOUT location where TV will be
mounted. Drop or wall-fish audio video cables and in-wall
PowerWire extension to the PowerIN cutout location.
Step 3
Power UP
Surge Protector
Plug supplied 6’ PowerConnect cord into PowerIN.
Plug other end into existing grounded outlet or surge protector.
Do not use another extension cord to extend the supplied cord.
!
B) Push in-wall PowerWire extension through the slot closest to the
middle of the attached wiring box. Push through approximately 6”
D) Slide BOTH OUT and IN panels into wall openings.
Use Flat-Blade screw driver to secure panel to wall.
The PowerBridge In-Wall Extension is now energized.
Existing
Outlet
C) Slide audio video cables through backside of CableGate.
Optional: Cable zip-tie straps can be used to secure cables through CableHoops.
E) Dual Outlet / Inlet Wire Connection
Secure the Power-Plates
to PowerPanels with
supplied slotted screws.
Insert BARE wire into the yellow wire
port with GREEN wire.
Insert WHITE wire into the yellow wire
port with WHITE wire.
Insert BLACK wire into the yellow wire
port with BLACK wire.
Insert wires
completely into
the wire-ports to
lock wires securely.
!
Caution.
Do not over tighten
Plug TV power supply cord in to PowerOUT and connect AV cables to TV.
Follow wall mount manufacture instructions, install TV on wall bracket.
Plug in TV
Plug in Flat Angle Plug in the far right receptacle
! Caution.
Do not over tighten
LP3D_v1413